What options will you get on your Arcimoto?

[ricschug]

I would settle for AM simply shipping units!!! However I do like the idea of future options being backward compatible.

[Rickb]

I found that the FUV’s narrow rear end provided for excellent side mirror visibility when backing during my test drive.  I doubt a backup camera will be a factory option.  I believe there are a number of aftermarket license plate frame backup cameras Bluetooth connected available.

[Kepesk]

I would actually be surprised if there weren't a backup camera option at some point. If they're going to automate these thins, that would seem to me to be a necessary step.

[Wulauki]

Solar Panel roof was one of the options on their site pre-Evergreen.

[PAX]

I found that the FUV’s narrow rear end provided for excellent side mirror visibility when backing during my test drive.  I doubt a backup camera will be a factory option.  I believe there are a number of aftermarket license plate frame backup cameras Bluetooth connected available.

On our Signature series i find that when backing up it is really tough to tell exactly where the rear wheel is headed because the tail end tapers.  I have done a ton of backing up using mirrors both with just my vehicle and with trailer (over 200 times per year for 24 years with my sail boat) so i have some experience and I cannot use the FUV mirrors to back up accurately. I am for the camera- have one on our Leaf and it helps.
Just my 2Cents

[DanPDX]

On our Signature series i find that when backing up it is really tough to tell exactly where the rear wheel is headed because the tail end tapers.  I have done a ton of backing up using mirrors both with just my vehicle and with trailer (over 200 times per year for 24 years with my sail boat) so i have some experience and I cannot use the FUV mirrors to back up accurately. I am for the camera- have one on our Leaf and it helps.
Just my 2Cents

PAX how is your Signature Series holding up? Would love to know your thoughts this many months later!

[PAX]

PAX how is your Signature Series holding up? Would love to know your thoughts this many months later!

It has been down at the factory for a while. I am not sure what all they are doing to it.  We should be getting it back soon. Good timing as the weather starts to warm up in the PNW at least.

[DanCooper]

Here's a crazy idea. Put horizontal fiberglass wands on the back, even with the back wheel or a little behind. Put red balls or something on the ends, lined up with the mirrors. It might help other drivers avoid cutting too close, too.

[Rickb]

The telescoping e-trailer hitch aligner may be exactly what you’re looking for!

https://m.youtube.com/watch?v=9N6UwVuXFJI

[PAX]

Here's a crazy idea. Put horizontal fiberglass wands on the back, even with the back wheel or a little behind. Put red balls or something on the ends, lined up with the mirrors. It might help other drivers avoid cutting too close, too.

Dan,   I had the same idea. It would solve the problem I have. Of course if i could turn my head 180 degrees that would also solve the issue.